User Tools

Site Tools


velodyne_faro_system

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
velodyne_faro_system [2015/12/16 15:07]
elaine.boyd
velodyne_faro_system [2015/12/16 15:41]
elaine.boyd
Line 1: Line 1:
 ====  Velodyne/​Faro System ​ ==== ====  Velodyne/​Faro System ​ ====
-  - Power up and start your access point. Wait one minute and then power your lumberjack logger and Velodyne/​FARO system. +  - Power up and start your Lumberjack logger'​s white access point. Wait one minute and then power your lumberjack logger and Velodyne/​FARO system
-  - Log in to your lumberjack logger and ensure it is properly configured to your INS and Velodyne unit in the “Settings” tab.{{ :​settings-view.png?​nolink&​200 |}}+  - Connect your cell phone, tablet, or computer to the access point'​s wifi network
 +  - Log in to your lumberjack logger ​with the credentials on the back of the access point and ensure it is properly configured to your INS and Velodyne unit in the “Settings” tab.{{ :​settings-view.png?​nolink&​200 |}}
   - Connect your ethernet cable to the Faro and your laptop computer and open FARO RT. Enter your Faro IP address (NOTE: The first three period delimited numbers of your laptop computer'​s LAN IPv4 address must match that of your Faro's IP address.){{ :​faro.jpg?​300 |}}{{ :​capture.jpg?​600 |}}   - Connect your ethernet cable to the Faro and your laptop computer and open FARO RT. Enter your Faro IP address (NOTE: The first three period delimited numbers of your laptop computer'​s LAN IPv4 address must match that of your Faro's IP address.){{ :​faro.jpg?​300 |}}{{ :​capture.jpg?​600 |}}
   - Choose your desired file destination and select "​Connect."​   - Choose your desired file destination and select "​Connect."​
velodyne_faro_system.txt · Last modified: 2016/08/05 14:30 by elaine.boyd

Bitnami