User Tools

Site Tools


tersus_base_for_rtk

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
tersus_base_for_rtk [2017/07/05 08:21]
elaine.boyd [Setting up your Tersus Base]
tersus_base_for_rtk [2017/07/19 10:11] (current)
elaine.boyd
Line 10: Line 10:
   * Open TersusGNSS Center (download here: https://​www.tersus-gnss.com/​pages/​document-software) and select or enter the assigned COM port number of the USB inserted.   * Open TersusGNSS Center (download here: https://​www.tersus-gnss.com/​pages/​document-software) and select or enter the assigned COM port number of the USB inserted.
   * If this is first time set up enter the following in the command line:   * If this is first time set up enter the following in the command line:
-    * Lat and Long are measured in decimal degrees. Alt is measured in meters above the ellipsoid (WGS84). For example, "FIX POSITION 34.24357 -86.234395 ​180.258". Do not forget to add in the rod and antenna phase center height.+    * Lat and Long are measured in decimal degrees. Alt is measured in meters above the ellipsoid (WGS84). For example, "FIX POSITION 34.459884 ​-86.824432 ​180.273". Do not forget to add in the rod and antenna phase center height.
  
      ​UNLOGALL      ​UNLOGALL
tersus_base_for_rtk.txt ยท Last modified: 2017/07/19 10:11 by elaine.boyd

Bitnami