User Tools

Site Tools


snoopy_uav

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
snoopy_uav [2017/08/14 06:40]
elaine.boyd [Connecting to Lumberjack with built-in Access Point - A Series, TRex and Revolutions]
snoopy_uav [2017/08/14 06:40] (current)
elaine.boyd [Connecting to Lumberjack with built-in Access Point - A Series, TRex and Revolutions]
Line 10: Line 10:
     - Your scanner head should start spinning (and for A-Series users, the three LEDs below your power cable should light red and green).     - Your scanner head should start spinning (and for A-Series users, the three LEDs below your power cable should light red and green).
   - Wait one minute and use your mobile device (computer, laptop, tablet, cell phone, etc.) to connect to the WiFi network of the scanner. Format of the access point name is the Serial Number of the scanner + "​AP"​ - i.e. AHS-17-XXXX-XXAP   - Wait one minute and use your mobile device (computer, laptop, tablet, cell phone, etc.) to connect to the WiFi network of the scanner. Format of the access point name is the Serial Number of the scanner + "​AP"​ - i.e. AHS-17-XXXX-XXAP
-  - Open an internet browser from your device and enter "​192.168.0.1"​ into the address bar.+  - Open an internet browser from your device and enter "​192.168.0.1"​ into the address bar. The web address is also labeled on your scanner.
  
 **At this point you will see a webpage similar to the one shown below ** **At this point you will see a webpage similar to the one shown below **
snoopy_uav.txt ยท Last modified: 2017/08/14 06:40 by elaine.boyd

Bitnami