User Tools

Site Tools


order_of_connecting_to_ladybug

Order of Connecting to the LadyBug 5

From this point forward, it is assumed your Snoopy system is powered on and the Snoopy to Ladybug connectors (gray cable) are screwed together.

  1. Connect the blue USB 3.0 cable (connected to hub) into a USB 3.0 or USB SS port onto your laptop computer.
  2. Wait one minute and proceed to connect the black USB cable from the camera to the USB hub.
    1. The portion of the image outlined in red is the initial connection.
    2. You must be connected to a USB 3.0 port to properly connect to the LadyBug.
  3. Open LadyBugCap from program list. The icon MUST appear as in the following image.
  4. Choose the camera and press OK.
    1. NOTE: If the Camera List Interface displays “USB 2.0” and not “USB 3.0” you must disconnect the black USB cable from the USB Hub, wait several seconds, and reconnect.
    2. If at first you don't succeed to get the camera at more than USB 2.0, try 3-4 more times. After this point it may be necessary to try the connection without the hub - straight from the camera to the computer using the black USB 3.0 cable.
    3. If the camera does not appear in the list at all, be sure that the seating of the USB into the camera is securely fastened. It may require a small flathead screwdriver to tighten. These cables have sensitive connections that need not waiver.
  5. To continue… How to Use LadyBugCap
order_of_connecting_to_ladybug.txt · Last modified: 2016/08/22 13:50 by elaine.boyd

Bitnami