User Tools

Site Tools


golook_camera_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

golook_camera_setup [2016/01/04 14:32]
elaine.boyd created
golook_camera_setup [2016/01/04 14:33] (current)
elaine.boyd
Line 1: Line 1:
 +==== GoLook Camera Setup ====
 GoLook requires a clean, isolated 12 VDC power supply capable of providing approximately 35W or 3A. In the power cable supplied, the white wire is positive voltage (+) and the black is negative (-) or ground. Be certain this is correctly connected to the power supply. It is recommended to add an inline on/off switch or connector to GoLook’s power cable but not necessary. GoLook requires a clean, isolated 12 VDC power supply capable of providing approximately 35W or 3A. In the power cable supplied, the white wire is positive voltage (+) and the black is negative (-) or ground. Be certain this is correctly connected to the power supply. It is recommended to add an inline on/off switch or connector to GoLook’s power cable but not necessary.
   - Verify that each 64GB micro SD card is formatted as exFAT and has the config.txt file in the root directory – for more information on this file, see Configuration and Troubleshooting.   - Verify that each 64GB micro SD card is formatted as exFAT and has the config.txt file in the root directory – for more information on this file, see Configuration and Troubleshooting.
golook_camera_setup.txt · Last modified: 2016/01/04 14:33 by elaine.boyd

Bitnami